Fig. 7.52. Sealed connector of the crankshaft position sensor.
Move the sensor wire to the side and remove the sensor mounting plate from the clutch housing (Fig. 7.53).
Fig. 7.53. Removing the crankshaft position sensor.
1 — location of sensor installation; 2 — sensor; 3 — sensor mounting plate;
4 - rubber lining.
Bend the wire fastening tab and remove the sensor. Separate the rubber gasket from the sensor and replace it if it is defective. The sensor is installed in the reverse order of removal. After installation, check the gap between the flywheel and the sensor, which should be within 0.8-1.2 mm. If the gap is less than 0.4 mm, install adjusting washers.
To replace the wire tips, disconnect them from the spark plugs, unscrew them and screw new blue tips onto the wires.