Cylinder Head Temperature Sensor (CHT) (1.8L/2.0L/1.6L Zetec-E) (Focus 1)

Removal

1. Remove the generator. For additional information, refer to Section 414-02.

2. Disconnect the electrical connector of the cylinder head temperature sensor (CHT).

2. Disconnect the electrical connector of the cylinder head temperature sensor (CHT).

3. Remove the cylinder head temperature sensor (CHT).

Installation

1. Install the elements back in place in reverse order.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Yaroslav Gorbunov

« Previous articles
Cylinder Head Temperature Sensor (CHT) (1.6L Zetec-SE/1.4L)
Knock Sensor (KS) (1.4L/1.6L)
Heated Oxygen Sensor (HO2S) (1.8L/2.0L/1.6L Zetec-E)
Heated Oxygen Sensor (HO2S) (1.8L/2.0L)
Heated Oxygen Sensor (HO2S) (1.6L Zetec-SE/1.4L)

Next articles »
Cylinder Head Temperature Sensor (CHT) (1.8 l diesel)
Clutch Pedal Position Switch (CPP)
Injector Control Module (IDM) (1.8L Diesel)
Fuel Pump Control Module (FPDM) (Duratec ST 2.0L)
Intake Manifold Runner Control (IMRC) actuator

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Focus 2

Focus Turnier 1
Focus 1