Radiator lining 1 is attached to the engine compartment frame with two pinsaand is held at the bottom by two clamps that fit into the grooves of the front bumper. To the trim by four pistons ban air guide shield 2 is attached, blocking access to the hood lock drive installed on the radiator grille. In order to remove the radiator grille, it is necessary to disconnect the drive from the hood lock, and for this, the shield must first be removed.
You will need a Phillips-head screwdriver.
1. Open the hood and place it on the support.
2. Unscrew the fasteners of the four pins securing the air guide shield to the radiator grille..
3. …pry up the pins with a screwdriver…
4. …push up the two shield latches located on its rear edge…
5. …and remove the shield.
6. Remove the two pins securing the radiator grille to the engine compartment frame in the same way as you did when removing the air guide shield…
7. …disconnect the trim from the frame by removing its two lower holders from the grooves in the front bumper…
8. …disconnect the drive from the lock, overcoming the elastic resistance of the retainer…
9. …and remove the radiator grille.
10. Install the parts in the reverse order of removal.