1. Open the hood and place it on the support.
2. Remove the radiator grille (see "Removing and installing the radiator grille").
3. Remove the mudguard and engine crankcase protection (see "Removing and installing the engine mudguard").
4. In the arches of both front wheels, turn out one lower…
5. …and two front screws for attaching the mudguards to the bumper...
6. …and also two bolts for the outer fastening of the front bumper to the front fenders.
7. Using a puller…
8. …or with a screwdriver…
9. … remove the two pins securing the bumper to the side pillars of the radiator frame.
10. On both sides of the car, unscrew one bolt of the inner fastening of the bumper to the front fenders…
11. …unscrew the fasteners…
12. …and remove one pin each securing the bumper to the engine compartment frame…
13. …on both sides, use your finger to press the two latches securing the bumper to the engine compartment frame…
14. …and sink the latches into the holes in the frame…
15. …press down the two side fasteners and move the edges of the bumper away from the engine compartment frame.
16. Unfasten the three central fasteners…
17. …and remove the front bumper.
18. Install the front bumper and all removed parts in the reverse order of removal.
NOTE: The front bumper beam is part of the engine compartment frame, so the removal and installation of the frame are described in a separate subsection (see "Removing and installing the engine compartment frame and front bumper beam").