Accelerator cable (Duratec ST 2.0 l) — removal and installation (Focus 1)

Removal

1. Remove the cover from the throttle body.



2. Disconnect the accelerator cable from the throttle body.

• 1. Remove the clamp and disconnect the cable from the throttle body.
• 2. Turn the outer cable sheath.

3. Release the accelerator cable from the clamp.

4. Remove the footwell trim panel.



5. Disconnect the accelerator cable from the pedal.





6. To make installation easier, tie a wire to the accelerator cable that can be used to pull the cable.



7. Remove the accelerator cable.

Installation

1.

NOTE: Before installing the accelerator cable into the grommet, the rubber grommet must be inserted into the bulkhead.

Install the elements back in place in reverse order.

The original source of this article can be found at: fordbook.ru