| Name | |
| Type | Single-disc dry clutch |
| Drive | Hydraulic |
| Outer diameter | 228 mm |
| Pedal travel (non-adjustable) | 133±3 mm |
Tightening torques
| Name | Nm | pound-foot | pound-inch |
| Clutch pressure plate to flywheel | 29 | 21 | - |
Clutch elements
| Pos. | Spare Part No | Name |
| 1 | Clutch pressure plate | |
| 2 | Slave (friction) clutch disc | |
| 3 | Flywheel |
The clutch transmits torque from the engine to the gearbox. The clutch includes a driven (friction) disk and a pressure plate, which is bolted to the flywheel.
When the clutch is engaged (the clutch pedal is depressed), the power flow between the engine and the gearbox is interrupted. This means that when the clutch is not engaged, it is in an engaged (not free) state. Once engaged, the clutch is disengaged (disengaged).
Slave and pressure plates of the clutch
Special tool
 | Clutch slave disc alignment tool 308-204 (16-067A) |
 | Flywheel Locking Tool 303-393 (21-168) |
Removal
1. Remove the transaxle. For additional information, refer to Section 308-03A / 308-03B / 308-03C.
2.
CAUTION: Loosen the clutch pressure plate mounting bolts evenly, turning two turns at a time.
Using a special tool, remove the clutch slave and pressure plates. Discard the bolts.
Installation
1. Using the special tool, center the clutch slave disc on the clutch pressure plate.
2.
CAUTION: Tighten the clutch pressure plate mounting bolts finger tight, then tighten the bolts evenly, two turns per step, to the specified torque.
NOTE: Install new clutch pressure plate mounting bolts.
Using a special tool, install the clutch slave and pressure plates.
3. Remove the special tool.
4. Install the transaxle. For additional information, refer to Section 308-03A / 308-03B / 308-03C.
Visitor comments