Contents: Removal ↳ Installation ↳
| Name | Specification |
| High temperature grease | ESDM-1C220-A |
Removal
1. Remove the transmission. For additional information, refer to Section 308-03A / 308-03B / 308-03C.
2.
WARNING: Avoid contact with skin or eyes with brake fluid. If brake fluid comes into contact with skin or eyes, rinse the affected area with water immediately. Failure to follow these instructions may result in injury.
CAUTION: If brake fluid comes into contact with the vehicle's paintwork, immediately wash the affected area with water.
Remove the clutch slave cylinder.
- 1. Remove the bolts.
- 2. Connect the slave cylinder to the clutch.
Installation
1. Install the clutch slave cylinder.
- 1. Apply high temperature grease to the input shaft splines.
- 2. Insert the clutch slave cylinder.
- 3. Tighten the bolts.
2. Bleed the clutch hydraulic system. Refer to Section 308-00 for additional information.
3. Install the transmission. For additional information, refer to Section 308-03A / 308-03B / 308-03C.
(This article is a copy from the website: FordBook.ru)