Special tool
 | Hand Vacuum/Pressure Pump 416-D001 (23-036A) |
General equipment: Syringe
| Name | Specification |
| Super DOT 4 Brake Fluid | ESD-M6C57-A |
WARNING: Brake fluid contains polyglycerol esters and polyglycerol. Avoid contact with eyes. Wash hands thoroughly after handling brake fluid. If brake fluid gets into your eyes, flush eyes with cold running water for 15 minutes. If irritation persists, seek medical attention. If brake fluid is swallowed, drink water and induce vomiting. Seek immediate medical attention. Failure to follow these instructions may result in injury.
CAUTION: If brake fluid comes into contact with the paintwork, the affected area must be immediately washed with cold water.
1.
CAUTION: Do not allow the brake fluid reservoir cap to become contaminated.
Remove the brake fluid reservoir cap.
2. Using a suitable syringe, pump out the brake fluid from the brake fluid reservoir until the fluid level drops to the MIN mark.
3. Remove the dust cap from the bleed nipple of the clutch slave cylinder.
4. Using a special tool, remove air from the clutch system.
- 1. Pour approximately 100 ml of new Super DOT 4 brake fluid into the special tool reservoir.
- 2. Connect the reservoir hose to the clutch slave cylinder bleed nipple.
- 3. Release the nipple to remove air from the clutch slave cylinder.
- 4. Pump approximately 80 ml of brake fluid into the clutch system.
5. Tighten the bleed nipple to remove air from the clutch slave cylinder.
6. Remove the special tool.
7. Install the dust cap on the bleed nipple of the clutch slave cylinder.
8. Check the brake fluid level in the brake fluid reservoir and, if necessary, add Super DOT 4 brake fluid.
9. Install the cover on the brake fluid reservoir.