Fluid pan, gasket and filter (Focus 1)

Special tool

Oil pan puller 303-428 (21-179)

Name	Specification
Metal Surface Cleaner	WSE-M5B392-A
Loctite 5699	WSS-M4G-320-A3
Transmission fluid for automatic transmission	WSS-M2C202-B

Removal

1. Raise and support the vehicle. Refer to Section 100-02 for additional information.

2.

NOTE: Place a suitable container under the transmission fluid reservoir.

NOTE: This crankcase is filled with transmission fluid; it is impossible to drain the transmission fluid from the crankcase before removing it.

Remove the transmission fluid housing.

• Remove the bolts.
• Using a special tool, remove the bead of sealant.

3. Thoroughly remove sealant from the surfaces of the transmission fluid case and transaxle case using metal cleaner or equivalent.

Installation

1. Apply a 1.5mm thick bead of Loctite 5699 to the transmission fluid pan.



2. Install the transmission fluid reservoir.



3. Lower the vehicle.

4. Check the transmission fluid level.

The material was copied from an information website (FORDBOOK)