WARNING: The door window anti-grab function will not operate while the door window motor initialization procedure is in progress. Make sure the door window opening is clear of any foreign material. Failure to follow these instructions may result in injury.
NOTE: After disconnecting the battery, it is necessary to initialize the window lift motor for each door individually.
1. Press the window control switch so that the door window is completely closed, and hold the button in the window closing position for another second.
2. Release the close button on the window control switch and press it again two or three times, holding it down for one second each time.
3. Press the open button on the window control switch until the door window is fully opened.
4. Press the button on the window control switch to the second detent position and release it.
- If the door window does not close automatically, repeat the complete procedure.
5. Repeat the door window lift motor initialization procedure for the door window lift motor.
Visitor comments