Contents: Removal ↳ Installation ↳
Removal
Open the door.
Model with electric window: Using a small screwdriver, pry the window switch out of the door trim and disconnect its plug connector.
Model without electric window: Use a small screwdriver to pry up the window crank cover and remove the mounting screw located underneath. Remove the window crank.
Unscrew screw "1" securing the door release mechanism cover and remove the cover by moving it forward "2".
Front door: Remove both plugs and unscrew the screws underneath that secure the door trim pocket.
Remove the lining pocket from the lower clamps.
Remove 2 screws securing the armrest.
Rear door: Remove the ashtray and unscrew the screws securing the door release mechanism trim. Two screws are located under the ashtray and one screw is in the recess for the door release mechanism handle.
Remove the 4 mounting screws at the front and rear edges of the door trim.
Remove the door trim at the top from the two clamps, then pull the trim out of the lower U-shaped holder.
If present, disconnect the speaker plug.
Installation
If available, connect the speaker plug.
Insert the trim at the bottom into the U-shaped holder and, if available, pull the wire for the electric window through the hole in the trim. Press the trim at the top so that it is fixed in the clamps.
Place and screw on the door release mechanism cover.
Rear door - insert ashtray.
Place and screw the armrest.
Front door, secure in clamps and screw door trim pocket. Press in place plugs of holes for fastening screws.
Model without electric window lift: attach and screw the window lift crank. Press the screw hole plug into place.
Model with electric window: connect the plug connector of the window switch and fix the switch in the hole in the door trim.
Tighten the 4 mounting screws at the front and rear edges of the door trim.