You will need: keys "10", "13", "15", Allen key "6".
1. Set the steering wheel to a position corresponding to straight-line movement of the vehicle.
Note: To prevent damage to the airbag contact disc, secure the steering wheel from turning using the ignition locking mechanism of the anti-theft device. To do this, remove the key from the ignition and turn the steering wheel slightly until the shaft is secured by the anti-theft device.
2. In the car's interior, under the instrument panel, unscrew the bolt that connects the steering shaft to the steering gear shaft..
3. …and separate the shafts.
4. Remove the front suspension cross member assembly with the lower arms, steering gear and stabilizer bar (see "Removal and installation the front suspension crossmember").
5. Remove the three bolts securing the heat shield…
6. …and remove the heat shield.
7. Remove the drain pipe bracket mounting bolt…
8. …remove the pipe tip from the steering gear…
9. …and remove the pipeline.
10. On the left side, unscrew the bolt securing the steering gear to the engine crossmember, holding the nut with a second wrench to prevent it from turning, and remove the bolt.
11. Similarly, unscrew the steering gear mounting bolt on the right side..
12. …and remove the steering gear.
13. Install the steering gear in the reverse order of removal.
14. Bleed the power steering system (see "Bleeding the power steering system").
(The original version can be found on the website: FORDBOOK.ru)