Special tool
 | Universal Flange Holding Wrench 205-072 (15-030A) |
 | Bolt Tightening Angle Gauge 303-174 (21-540) |
 | Crankshaft Seal Remover 303-293 (21-143) |
 | Oil Pump Alignment Tool 303-652 (21-230) |
Removal
1. Remove the accessory drive belt. Refer to Section 303-05 for additional information.
2. Using a special tool, remove the crankshaft pulley. Discard the bolt as it is no longer needed.
3. Using a special tool, remove the crankshaft seal. Discard the seal as it is no longer needed.
Installation
All cars
1.
NOTE: Install a new front crankshaft seal.
Using the special tool, install the front crankshaft seal.
Vehicles without common rail fuel injection
2.
NOTE: Install a new crankshaft pulley bolt.
Using a special tool, install the crankshaft pulley.
- Tighten the crankshaft pulley bolt in two stages.
- Stage 1: 90 Nm
- Stage 2: 90 degrees
Vehicles with common rail fuel injection system
3.
NOTE: Install a new crankshaft pulley bolt.
Using a special tool, install the crankshaft pulley.
- Tighten the crankshaft pulley bolt in two stages.
- Stage 1: 110 Nm
- Stage 2: 255 Nm
All cars
4. Install the accessory drive belt. Refer to Section 303-05 for additional information.
(The text was obtained in its entirety from the specified website FORDBOOK.RU)