Withdrawal
1. Remove the floor console. See Section 501-12 for more information.
2. Disconnect the overdrive switch electrical connector (O/D) (gear selector shown in removed position).
3. Remove the shift lock actuator.
- 1. Turn out a bolt.
- 2. Remove the handle.
- 3. Pull out the pusher.
Installation
1. Install the shift lock actuator.
- 1. Install the pusher.
- 2. Replace the handle.
- 3. Install the bolt.
2. Mate the electrical connector of the O/D switch (gear selector shown in removed position).
3. Install the floor console. See Section 501-12 for more information.
Visitor comments