Adjusting the front planetary gear brake band
1 – adjusting bolts, 2 – lock nuts, 3 – gear reduction lever
1. Disconnect the cable from the gear reduction lever (B).
2. Loosen the nuts (B) locking the adjusting bolts (A) and unscrew these bolts a few turns.
3. Using torque wrench 17.005, tighten the adjusting bolt until the wrench clutch disengages. If wrench 17.005 is not available, tighten the bolts to 13 Nm.
4. Loosen the adjusting bolt two turns and lock it in this position with the nut.
5. Connect the cable to the gear reduction lever.
The original source of this article can be found at: Fordbook.ru