Power steering hydraulic pump
1 – pump, 2 – supply pipeline, 3 – pressure pipeline, 4 – discharge pipeline, 5 – tank, 6 – pulley, 7 – flange, 8 – bearing, 9 – drive shaft, 10 – rotor, 11 – ring
All petrol engines except DOHC
V6 Power Steering Pump Pivot Bolt
1. Remove the ground wire from the battery.
2. Place a suitable container under the hydraulic pump.
3. Cover the generator with plastic wrap so that it does not come into contact with power steering fluid.
4. Wipe down the areas around the connections, then disconnect the high pressure and return pipes from the pump and tank.
5. On the pump, loosen the pulley mounting bolts, remove the V-belt and pulley.
6. Unscrew the pump mounting and adjustment bolts and remove the pump.
DOHC engines
Three pump mounting bolts accessible after unscrewing and removing the DOHC engine pump pulley
The pump is mounted on a suspension on the front right side of the cylinder block. To improve access to the pump, raise and secure the front of the car on stands.
1. Place a suitable container under the hydraulic pump, unscrew the pipeline couplings and drain the liquid.
2. Remove the drive belt.
3. Unscrew the three pulley mounting bolts and remove the pulley from the pump.
4. Remove the three pump mounting bolts from the front of the suspension and one bolt from the rear of the suspension and remove the pump.
5. To install the pump, perform the steps in reverse order to the process of its removal. During this process, pay attention to:
- correct tension of V-belts;
- installation of new gaskets for hydraulic pipeline connections;
- correct filling of oil and bleeding of air from the steering system.
Cars with diesel engines
Connection points of pipelines to the hydraulic pump
1 – pressure pipeline, 2 – discharge pipeline
Hydraulic pump mounting bolts
1 – mounting bolt, 2 – fastening bolts
1. Remove the ground wire from the battery.
2. Raise the front of the vehicle and secure it on stands.
3. Remove the front mudguard under the engine compartment.
4. Place a suitable container under the hydraulic pump.
5. Loosen the clamp, remove the drain pipe and drain the oil from the system.
6. Unscrew the clamp and remove the pressure pipe.
7. On the pump, loosen the pulley mounting bolts, remove the V-belt and pulley.
8. Unscrew the adjustment lever from the pump.
The article was taken in its entirety from the specified website www.fordbook.ru