Rear Disc brake pads (Focus 1)

Special tool

Rear Caliper Piston Retractor 206-012 (12-006)

Removal

1. Loosen the wheel nuts.

2. Raise and support the vehicle. Refer to Section 100-02 for additional information.

3. Remove the wheel.

4. Disconnect the parking brake cable.

• 1.Pull back the parking brake lever.
• 2. Disconnect the cable from the parking brake lever.
• 3.Remove the cable sheath clamp.
• 4. Disconnect the cable and cable sheath.

5.

CAUTION: Secure the caliper to the side to avoid damaging the brake hose.

Disconnect the caliper.



6. Remove the brake pads.

Installation

1.

CAUTION: If the pistons are retracted into the housing, brake fluid may be forced out of the master cylinder.

Using a special tool, push the caliper piston all the way in.



2. Install the brake pads.



3.

NOTE: Make sure the brake shoe springs are positioned correctly on the caliper.

Install the caliper.





4. Connect the parking brake cable.

• 1. Install the cable and cable sheath in the required position.
• 2. Install the cable clamp.
• 3.Pull back the parking brake lever.
• 4.Connect the cable to the parking brake lever.

5. Install the wheels.