Special tool
 | Front Caliper Piston Retractor 206-005 (12-014) |
Removal
CAUTION: If brake fluid comes into contact with the paintwork, the affected area must be immediately washed with cold water.
1. Loosen the wheel nuts.
2. Raise and support the vehicle. Refer to Section 100-02 for additional information.
3. Remove the wheel.
4. Disconnect the brake hose from the support bracket.
5. Disconnect the outer brake shoe mounting clamp.
6.
NOTE: Pull the caliper outward to release the piston.
Disconnect the caliper.
- 1.Remove the bolt covers.
- 2. Unscrew the bolts.
7. Suspend the caliper to avoid pressure on the brake hose.
8. Lift the outer brake pad retaining clamp over the spring loaded clamp tabs.
9. Remove the outer brake shoe.
10. Remove the inner brake shoe.
Installation
1.
CAUTION: If the caliper piston is retracted into the housing, brake fluid will be forced out of the master cylinder.
Press the caliper piston all the way in.
2.
CAUTION: Make sure the disc surface is clean before installation.
Install the inner brake shoe.
3.
CAUTION: Make sure the disc surface is clean before installation.
Install the outer brake shoe.
4. Push the outer clamp of the fastener over the spring-loaded clamping tabs
5. Install the caliper.
- 1.Install the bolts.
- 2.Install the bolt covers.
6. Install the brake hose to the support bracket.
7. Install the outer brake shoe mounting clamp.
8. Install the wheels.
9. Check the brake fluid level in the brake hydraulic reservoir.
Visitor comments