Replacing the economizer valve diaphragm (Weber 2V TLD) (Scorpio 1)

1. Remove the ground wire from the battery and the air filter housing.

2. Unscrew the three screws securing the cover, remove the economizer valve cover and remove the spring.

3. Remove the diaphragm from the housing flange.

4. Installation is carried out in the reverse order of removal.

Attention! The replacement of the remaining carburetor diaphragms is carried out in a similar manner.

The text of the article was copied from the website FordBook

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Herman Ostrovsky

« Previous articles
Secondary Throttle Valve Vacuum Drive (Weber 2V TLD)
Float chamber needle valve (Weber 2V TLD)
Adjusting idle speed and mixture quality (Weber 2V TLD)
Removal and installation the Weber 2V TLD carburetor
WEBER 2V TLD Carburetor — Design Description

Next articles »
Automatic starting device (Weber 2V TLD)
Fast Idle Speed Adjustment (Weber 2V TLD)
Removal and installation the throttle damper (Weber 2V TLD)
Weber 2V TLD Carburetor Adjustment