Attention! Release the pressure in the hydraulic accumulator of the brake system. To do this, turn off the ignition and press the brake pedal all the way (about 20 times) until it becomes "hard".
2. Remove the trim under the instrument panel on the driver's side.
3. Remove the spring clip securing the brake pedal (2) to the hydraulic unit pushrod (1).
4. Remove the brake pedal shaft by moving it to the left until the brake pedal is released.
5. Remove the brake pedal, noting the order of the washers and gaskets.
6. Installation is carried out in the reverse order of removal.
7. After installing the pedal, check the operation of the brake light switch.
[This article is a copy from the website: FORDBOOK.ru]