Contents: Removal ↳ Installation ↳
Caution! The brake fluid in the rear brake circuit is under high pressure. Do not press the brake pedal.
Removal
1. Loosen the nuts securing the corresponding rear wheel.
2. Raise the car and remove the wheel.
3. Release the handbrake lever.
4. Raise the rear seat and tilt the floor covering forward.
5. Remove the wire from the bracket and disconnect the electrical connector (indicated by the arrow) from the wheel speed sensor.
6. Disconnect the handbrake cable from the bracket on the rear suspension arm.
7. Remove the front brake caliper mounting bolt.
8. Turn the caliper upward.
9. Unscrew the sensor mounting bolt and remove it.
Installation
1. Clean the wheel speed sensor mounting socket from dirt, traces of rust, etc.
2. Lightly lubricate the sensor mounting socket with bearing grease.
3. Install a new O-ring onto the sensor.
4. Perform the same initial steps as when installing the front wheel speed sensor in subsection 11.6.6, and then perform the steps described when removing the rear wheel speed sensor in reverse order.
A copy of the article is available on the website: fordbook.ru