Removal and installation a car radio (Fusion)

            0

Attention! Ford Fusion cars are equipped with car radios that have a security code. As a rule, during the pre-sale preparation, the Ford dealer already enters the code.


Attention! When disconnecting the battery or removing the car radio, the security code must be re-entered.


Attention! Ten attempts to enter the security code are allowed. The number of attempts is displayed on the LCD display of the car radio.


Warning! After ten incorrect attempts to enter the code, the radio will lock and the message "LOCKEL" will appear on the LCD display. In this case, you must contact your Ford dealer.


To remove the car radio you will need special pullers.

Note: If you do not have special pullers, you can use four thin plates of suitable size.


1. Disconnect the wire from the negative terminal of the battery.

1. Disconnect the wire from the negative terminal of the battery.


2. Insert the pullers into the holes shown in the photo…

2. Insert the pullers into the holes shown in the photo…


3. …and remove the car radio from the center console of the instrument panel.



3. …and remove the car radio from the center console of the instrument panel.


4. Disconnect the antenna wire connector.

4. Disconnect the antenna wire connector.


5. Squeeze the latch…

5. Squeeze the latch…


6. …lift the shoe clamp…

6. …lift the shoe clamp…


7. …disconnect the wiring harness and remove the car radio.

8. Install the car radio in the reverse order of removal.

The original version can be found on the website Fordbook.ru






Link to this page in different formats


Visitor comments

No comments yet



Fusion 
Scorpio 1 
Scorpio 2 
Sierra 
We use cookies to ensure the site works smoothly, remembers your settings, and is convenient for you 🍪