1. Remove the rear door trim (see "Removal and installation the rear door trim").
2. Remove the speaker from the corresponding side (see "Removal and installation speakers of the acoustic system").
3. Use a screwdriver to pry up the rear door wiring harness connector retainer and remove the connector from the pillar cavity…
4. …disconnect the connector…
5. …and push the wire harness into the door cavity.
6. Remove the plug of the technological hole from the base of the window regulator…
7. …holding the glass, press the plastic retainer with a screwdriver and remove the retainer from the hole in the glass.
8. Remove the window lift handle spacer sleeve.
9. Raise the glass to the upper position with your hands, removing it from the window regulator bracket, and secure the glass with a screwdriver installed in the technological hole in the front part of the door.
10. Push the door lock drive seal into the door cavity.
11. Remove the nine bolts securing the window lifter base to the door…
12. …disconnect the base from the door by removing the door lock drive from the hole in the base…
13. …remove the plastic retainer of the door lock wiring harness connector…
14. …disconnect the block from the lock terminals…
15. …and remove the window regulator base.
16. Remove the two screws securing the window regulator to its base…
17. …and remove the window regulator from the upper…
18. …and the lower pins on the base.
19. Install the rear door window regulator in the reverse order of removal.