Name | Specification |
Inner rear side panel | |
Reinforcing panel of the counterpart of the lock | |
Rack reinforcement panels «WITH» | |
Retractor mounting panel |
Withdrawal
1. General note.
- Before repairing, remove the rear side panel, rear panel and water drain panel along with its reinforcement panel.
2. Reinforcing panel of the counterpart of the lock
- Mill out the spot welds.
3. Outer wheel arch with inner rear side panel
- 1. Open the spot welds by cutting them.
- 2. Mill the spot welds (to a depth equal to twice the thickness of the panel).
4. Inner rear side panel
- 1. Places of cut
- 2. Remove the remaining flange from the rack reinforcement «WITH».
5. Seat belt attachment panel
- Mill out the spot welds on the inside.
Installation
1. Wheel arch with inner rear side panel and reinforcement panels
- 1. Perform a puddling weld.
- 2. MIG weld the inner rear side panel.
- 3. Do a puddling weld (to a depth equal to twice the thickness of the panel).
2. Seat belt attachment panel
- Perform a puddling weld.
Visitor comments