Rear side interior panel (3-door) (Focus 1)

General equipment: Measuring and straightening.

Name	Specification
Inner rear side panel
Inner Rear Side Panel Reinforcement - Upper
Inner Rear Side Panel Reinforcement - Bottom
Seat belt mounting reinforcement panel
Seat belt retractor mounting panel
Stand "B"

Removal

1. General note.

• Before starting repair, remove the rear side panel, water drain panel and water drain panel reinforcement.

2. Inner rear side panel

• 1. Cutting places
• 2. Cut (open spot welds).

3. Inner rear side panel

• 1. Cutting places.
• 2. Remove the remaining flanges.

4. Seat belt mounting panel

• Mill out the spot welds on the inside.

Installation

1. Inner rear side panel with reinforcement

• 1. Welding using MIG technology.
• 2. Perform puddling welding.

2. Stand "B"

• Before installing the new spare part, weld the seat belt mounting reinforcement panel.
• 1. Welding using MIG technology.
• 2. Perform puddling welding.

3. Seat belt retractor mounting panel.

• Perform puddling welding.

The original source of this article can be found at (FORDBOOK)