Insure the car against rolling. To do this, place wedges or stones under the other side of the car.
Install the jack only on the channel
Remove the decorative cap from the wheel. To do this, insert a screwdriver (side tools) between the rim and the cap and press the cap.
Loosen the wheel bolts (one turn).
Raise the vehicle. Install the jack only in the designated areas of the side channel.
Remove the wheel bolts.
Remove the wheel and place the new wheel (spare wheel) on the wheel hub.
Align the wheel on the hub - the holes in the rim should match the threaded holes in the wheel hub.
Install the wheel bolts and tighten them by hand.
Lower the vehicle, tighten the wheel bolts. The tightening torque should not exceed 85 Nm - tighten the nuts with a cross-shaped wheel wrench and do not hammer them in with a wheel wrench with an extension.
Install the cap, align the valve hole correctly.
After about 10 km, check the nuts again for tightness.
Maximum speed with emergency wheel - 80 km/h.