Removing the power window side window (front)

In the version with power windows, first disconnect the battery.

Side glass

All models

Remove the door trim as described above.

Remove the side impact protection.



Dismantle the speaker, if it is installed - disconnect the connector.

Remove the opening lever.

Remove the door sealing film, pre-cut the butyl adhesive strip with a plastic knife (one-time set). Do not touch the adhesive surface, otherwise the adhesive effect will be reduced.

Models with power windows

If installed, remove the jog relay (arrows).

Connect the power window connector.

Models without power windows

Install the power window handle.

All models

Unscrew the bolts on the glass holder - pre-align the bolts on the inlets.


Disconnect the glass from the crank mechanism - to do this, firmly hold the glass at the top of the window opening and turn the window lifter down.

Raise glass, slide forward and remove.

Complete installation in reverse order.

Power windows

Prepare the work up to point 10 by analogy with the side glass.

Block the glass at the top of the window opening.

Lower the window lifter.

Remove the window regulator. Loosen all bolts and carefully remove the mechanism from the door.

When installing, align the power window in the door and mount all parts in reverse order.



Slide the glass up and down. In case of heavy glass movement, if necessary, adjust the guide.