Removing side windows/window lifter (Mondeo 3)

Side glass

ORDER OF EXECUTION

Center the side window using the clamping screw in the service opening. To do this, lower the window by approximately 160 mm.

Centre the side glass using the clamping screw and lower it by approximately 160 mm.
Remove the door trim as described above.
Remove the door speaker as described above.
Remove the sealing film from the door. To do this, detach the adhesive surface with a plastic knife if possible. Try not to touch it with your hands, otherwise the adhesive effect may disappear.
Unscrew the clamping screws (indicated by arrows) in the service openings and…

Loosen the clamping screws (indicated by arrows) in the service openings.
…and remove the rubber gasket (indicated by the arrow) from the door.
Now you have room to pull out part of the glass 1 from the outside of the door. To do this, tilt the glass forward 2 and pull it out of the door.

Tilt the glass forward 2 and press outward 1.
When installing, make sure that the glass is inserted into the door from the outside.
Carry out the installation in reverse order.

[The full article is on the online resource: fordbook]

Article reviewed: Herman Ostrovsky

« Previous articles
Removing the front door trim
Removing the backrest of the rear seats
It is not recommended to remove the front seats yourself
Dismantling the outdoor antenna
Removing the speaker

Next articles »
Window lifter
Adjusting the window lift motor
Removing the door handle
Removing the steering lock