It is not recommended to remove the front seats yourself (Mondeo 3)

            0


The driver and the passenger in the Mondeo sit on so-called "Anti-Dive" seats. The seat furnishings are an integral part of Ford's "Interior Protection System" (IPS): their consoles are equipped with pyrotechnic belt pretensioners, which instantly tighten the seat belts during an accident, thereby minimizing the degree of slackness. If the seats are not removed correctly, the pretensioner may "ignite" and become unusable. If you decide to do the removal yourself, you should contact your Ford dealer for information on the necessary safety regulations.


Reduces slack: pyrotechnic seat belt pretensioner on front seats.

1 - Seat belt lock with sensor,
2 — Pyrotechnic seat belt tensioner,
3 - Working building,
4 - Gas generator,
5 — Ignition unit,
6 - Rotary element,
7 — Tensioner cable.




To prevent the seat belt stowage and tensioning system from being triggered accidentally, give the "current voltage" a chance to discharge: after disconnecting the battery, wait about one minute before pulling out the seat belt stowage and tensioning system plug. Otherwise, the airbag and pyrotechnic pretensioner will be triggered. And as a result - injuries in addition to the large costs of a new system kit.

Front seat



ORDER OF EXECUTION
  1. Disconnect the battery and then wait for about one minute.
  2. Tilt the seat all the way back and…
  3. …pull out the main plug of the seat belt tensioner, the seat load sensor and – if installed – the plug of the video system (indicated by the arrow).


    Pull out the main plug of the seat belt pretensioner.
  4. Remove the front screws and…
  5. …move the seat fully forward.
  6. Remove the belt mount from underneath the seat.


    Remove the seat belt fastening from below (tighten to 38 Nm during installation).
  7. Unscrew both rear trims from the tires and…
  8. …unscrew the rear seat screws. Then pull the seat out of the passenger compartment.
  9. Carry out the installation in reverse order and tighten the seat screws to a torque of 25 Nm.


(The original can be found on the specified resource: www.FordBook.ru)






Link to this page in different formats


Visitor comments

No comments yet



Mondeo 4 
Mondeo 3 
Mondeo 2 
Mondeo 1 and 2 
Mondeo 1 
We use cookies to ensure the site works smoothly, remembers your settings, and is convenient for you 🍪