Removal and installation the center console (Scorpio I, up to 1/92) (Scorpio 2)

Removal

Disconnect the negative (-) battery cable.

Caution: When the battery is disconnected, the contents of electronic memory devices, such as engine fault codes or radio codes, are erased. Before disconnecting, also read the instructions in the chapter "Removal and installation the battery".

Remove the rubber pad from the front shelf. Press the two plugs with a screwdriver and unscrew the mounting screws located underneath them.

Remove the middle shelf in front of the handbrake lever and unscrew the mounting screws located underneath it.

Loosen the gear shift lever handle.

Remove both rear side mounting screws.

Remove the center console together with the corrugated cover from the gearshift lever and handbrake lever and take it out of the car interior.

Installation

Place the center console together with the corrugated cover on the gear shift lever and set it to the installation position.

Insert and tighten the 5 mounting screws.

Insert the center shelf.

Press the plugs into the front shelf and place the rubber pad.

Connect the battery ground (-) cable.



If available, set the clock and enter the radio theft protection code.