Removal and installation of switches of heating of forward seats

You will need a flat blade screwdriver.

1. Disconnect a wire from the minus plug of the storage battery.



2. Use a screwdriver to pry off the edge of the upper decorative lining of the floor tunnel lining and disconnect the lining, overcoming the elastic resistance of its latches.



3. Raise the trim and, from its reverse side, disconnect the block of the wiring harness B from the block of switches for heating the front seats, squeezing the latch of its fastening. Squeeze the two latches A located on the sides of the switch block and remove the block from the cover hole.

4. Install the parts in the reverse order of removal.