Replacing the control unit for outdoor lighting and illumination of the instrument cluster

You will need a flat blade screwdriver.

1. Disconnect a wire from the minus plug of the storage battery.

2. Open the left front door.



3. Remove the end of the door seal from the door opening flanging.



4. Pry off the edge of the left decorative instrument panel cover with a screwdriver..



5….and remove the cover.



6. Through the hole in the instrument panel that opened after removing the cover, wring out the latches of the control unit for external lighting and illumination of the instrument cluster and push the unit out of the instrument panel socket.

NOTE: This is how the latches of the control unit for external lighting and illumination of the instrument cluster are located.

7. Take away the block from the panel of devices.



8. Press the clamp of the wiring harness block..



9.... disconnect the block from the block and remove the block.



10. Establish the block of management of external lighting and illumination of a combination of devices in an order, the return to removal.