Turn on the hazard warning lights, depress the clutch pedal, then, using the car's momentum, try to carefully move to the edge of the roadway and stop as far to the right as possible at the curb, and if possible, outside the roadway. Let the engine run for a couple of minutes at normal crankshaft speed at idle with the heater on full power.
WARNING: Do not stop the engine immediately! The only condition is to maintain the tightness of the cooling system. If a hose bursts or comes off, or another leak occurs, except for the liquid coming out from under the expansion tank cap, the engine will have to be stopped immediately.
After an overheated engine stops, local overheating of the coolant begins in the places where it contacts the most heat-stressed engine parts and vapor locks form. This phenomenon is called thermal shock.
1. Stop the engine.
2. Open the hood and inspect the underhood space. Determine where the steam is escaping from. When inspecting the engine, pay attention to the presence of coolant in the expansion tank, the integrity of the rubber hoses, radiator, thermostat.
WARNING: Never open the expansion tank cap immediately. The liquid in the cooling system is under pressure, when you open the cap the pressure will drop sharply, the liquid will boil and its splashes can scald you. If you want to open the expansion tank cap on a hot engine, first put a thick, dense rag on top and only then carefully turn the cap.
3. Look under the dashboard on the front passenger side to see if there is a leak or traces of coolant leaking from the heater radiator.
If a coolant leak is detected, the burst hose can be temporarily repaired with tape.
HELPFUL TIP: Reinforced (e.g. silver) adhesive tape, which can be purchased at auto parts stores, works especially well for this purpose.
A leak in a radiator, thermostat or heater is quite difficult to fix on the spot, so in such a situation it is necessary to add water to the cooling system and carefully monitor the temperature gauge while driving, periodically restoring the level in the cooling system.
WARNING: Long-term use of water instead of antifreeze leads to the formation of scale in the engine cooling system, deterioration of its cooling and, as a result, to a reduction in service life.
WARNING: Never add cold water to an overheated engine. Allow the engine to cool for at least 30 minutes with the hood open.
4. A broken or loose belt for the alternator and water pump almost always causes the engine to overheat. If the belt is intact, check its tension (see "Checking the accessory drive belt"). If a break occurs, replace the belt (see "Replacing the accessory drive belt").
5. The engine may overheat if the thermostat, which regulates the flow of liquid in the cooling system through the radiator or past it (to speed up the warming up of a cold engine), fails.
To check the thermostat, you need to check the temperature of the hose connecting the thermostat to the radiator on a warm engine. If the radiator hose is cold, the thermostat is faulty, there is no circulation through the radiator.
6. Very often, the cause of overheating of the engine, the cooling system of which is equipped with an electric fan, is the failure of the fan. Start the engine, monitor the temperature and pay attention to whether the cooling system fan turns on when the engine overheats. The reasons for the fan not turning on may be a blown fuse (fuse link), a faulty switching relay, oxidized contacts in block 2 of the wiring harness, a burnt-out additional resistance 3 of the fan or a burnt-out electric motor 1.
7. Start the engine, monitor the temperature and check whether the cooling fan turns on when the engine overheats. If it does not turn on, the cause may be a blown fuse (fuse), faulty relay, oxidized contacts in the wiring harness block, or a burnt-out electric motor. Replace fuse links 1 and 2 in the fuse and relay mounting block installed in the engine compartment. If the fan does not start working after replacing the fuse links, check the electric motor by taking two additional wires and supplying power to it directly from the battery. The wires must be securely fastened and insulated.
WARNING: Do not allow wires to short-circuit each other!
WARNING: Pay attention to the polarity of the connection: the electric motor must rotate so that the fan forces air through the radiator onto the engine, and the directions of the generated flow and the incoming (path) air flow coincide.
If the electric motor starts to work, the wiring, fuses or relay for turning on the cooling system fan are faulty; if not, the wiring or the electric motor itself is also faulty. The relay, fuses and electric motor are not repairable, replace them (see Section 10 "Electrical Equipment").
USEFUL TIP: There are two valves installed in the expansion tank cap: an inlet valve and an outlet valve. The outlet valve plays a major role in ensuring the optimal engine temperature. It maintains excess pressure in the system of at least 0.145 MPa (1.45 kgf/cm²), increasing the boiling point of the coolant and preventing intense vaporization. Unfortunately, if the valve is jammed in the closed position, overheating will cause a significant excess of excess pressure - more than 0.15 MPa (1.5 kgf/cm²), which can lead to a rupture of the expansion tank or a tear in one of the hoses. In turn, jamming of the valve in the open position leads to premature boiling of the coolant.
USEFUL TIP: Therefore, once a year, rinse the expansion tank cap with running water. If in doubt, replace the cap. Obviously, if you remove the expansion tank cap on an overheated engine and this action coincides with a thermal shock, then boiling of the liquid and the formation of air locks in the cooling system are guaranteed.
USEFUL TIP: Once a year, blow out the radiator cells with a stream of compressed air (for example, from a compressor), directing the stream first towards the oncoming air flow, and then in its direction to remove dirt, stuck insects and road debris from the radiator surface. This can partially restore the radiator's efficiency.
[The material was copied from an information website: www.fordbook.ru]