Primary shaft — disassembly and assembly

Special tool

308-045 Bushing/Oil Seal Installer (16-015)

General equipment:

• Double bearing puller
• Press

Name	Specification
Transmission Fluid for Manual Transmission	WSD-M2C200-C

Disassembly

1. Using an appropriate double bearing puller, remove the inner roller bearing.

• 1. Remove snap ring and discard.
• 2. Remove the inner roller bearing.

2. Remove the outer roller bearing.

Assembly

NOTE: Coat all components with clean manual transmission fluid before reassembly.

1. Using the special tool and an appropriate press, install the outer roller bearing.



2.

NOTE: Roller bearing groove must face out.

NOTE: Install a new input shaft snap ring.

Using the special tool, install the inner roller bearing.

• Install retaining ring.