Lubrication of the sliding joint of the overdrive transmission and the propeller shaft (every 20,000 km or 12 months) (Transit 2)

1. Apply the parking brake, then jack up the front of the vehicle and support it on stands.

2. Clean all surfaces adjacent to the grease fittings on the cardan shaft side of the sliding joint (see Figure 24.2).

Figure 24.2. Cardan shaft grease nipple (shown by the arrow).

3. Fill the grease gun with the recommended quality grease, press the tip of the gun onto the grease gun and pump the gun a couple of times to lubricate the internal sliding grooves.

4. Lower the vehicle to the ground after lubrication is complete.

This article was borrowed from the website: FORDBOOK.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Afanasy Koshelev

« Previous articles
Clutch cable lubrication (every 20,000 km or 12 months)
Checking the oil level in a manual transmission (every 20,000 km or 12 months)
Kingpin and steering bush lubrication — models with independent front suspension (every 20,000 km or 12 months)
Check and lubricate the hood and doors (every 20,000 km or 12 months)
Checking the air conditioning system (monthly/every 20,000 km or 12 months)

Next articles »
Lubrication of automatic transmission rods and levers (every 20,000 km or 12 months)
Lubrication and adjustment of parking brake rods and levers (every 20,000 km or 12 months)
Checking the universal joint and intermediate bearing of the propeller shaft (every 20,000 km or 12 months)
Inspection of the condition of the underbody and fuel and brake system pipelines (every 20,000 km or 12 months)
Exhaust system inspection (every 20,000 km or 12 months)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet