Inspection and verification
1. Check the validity of the customer's complaint.
2. Perform a visual inspection for obvious signs of mechanical or electrical damage.
Visual inspection table
Electrical factors:
- Fuse Box(s)
- Lamp(s)
- Chain(s)
- Electrical connector(s)
3. If an obvious cause for the problem you identified or the customer described is found, correct it (if possible) before proceeding with further actions.
4. If the cause is not visually obvious, check the malfunction symptom and refer to the Malfunction Symptom Table.
Table of signs of malfunctions
|
State |
Possible Causes |
Action |
|
•Reversing light(s) do not work, 4-door models only. |
•Fuse(s) •Chain(s) •Park/Neutral Position Switch (Manual Transmission), Transmission Range Sensor (Automatic Transmission) •Rear light unit •Central Junction Box (CJB) |
• Proceed to PINPOINT TEST AW |
|
•Reverse light does not work, 3/5-door models only. |
•Fuse(s) •Chain(s) •Park/Neutral Position Switch (Manual Transmission), Transmission Range Sensor (Automatic Transmission) •Reversing light •Central Junction Box (CJB) |
• Proceed to PINPOINT TEST AX |
|
•The reversing light does not work, only for the Station Wagon models. |
•Fuse(s) •Chain(s) •Park/Neutral Position Switch (Manual Transmission), Gear Range Sensor (Automatic Transmission). •Rear light unit •Central Junction Box (CJB). |
• Proceed to AY PINPOINT TEST |
|
•The reversing light(s) are on continuously. |
•Chain(s) •Park/Neutral Position Switch (Manual Transmission), Gear Range Sensor (Automatic Transmission). •Central Timer Module (CTM) •Powertrain Control Module (PCM) •Central Junction Box (CJB) |
• Go to PINPOINT TEST AZ |