Contents: Removal ↳ Installation ↳
Removal
Disconnect the negative (-) battery cable.
Caution: When the battery is disconnected, the contents of electronic memory devices, such as engine fault codes or radio codes, are erased. Before disconnecting, also read the instructions in the chapter "Removal and installation the battery".
Loosen the bolts securing the lower steering column trim and remove the trim.
Unscrew the four bolts securing the upper steering column trim and remove the trim.
Cars up to 1/92: Remove the horn button from the steering wheel.
Cars from 2/92: remove the steering wheel, see p. 104.
Caution: Strictly observe safety precautions when working with an inflatable airbag.
Cars up to 1/92: Turn the steering wheel so that you can access the screws that secure the turn signal/hazard warning light switch "arrow" or the windscreen wiper switch, respectively.
Loosen the mounting screws and remove the turn signal/hazard warning light switch or windscreen wiper switch from the steering column.
Disconnect the multi-pin plug connector of the switch.
Installation
Connect the multi-pin plug connector of the switch.
Attach the switch to the steering column and screw it on.
Cars up to 1 /92: Install a horn button on the steering wheel.
Cars from 2/92: install steering wheel, see p. 104.
Attach and bolt the upper and lower steering column trims.
Connect the ground (-) cable to the battery.
If available, set the clock and enter the radio theft protection code.
Check the operation of the switches on the steering column.
[The text was obtained in its entirety from the specified website fordbook]