Fuel trap on engines with carburetor (Scorpio 1)

On carbureted engines, the fuel trap is installed in the vacuum pipe between the intake manifold and the ESC II unit.

1. Remove the negative cable from the battery.

2. Disconnect the vacuum pipes from the trap and remove it.

3. Install the fuel trap with the end labeled "CARB" toward the manifold and the end labeled "DIST" toward the block.

The material was copied from an information website www.fordbook.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Herman Ostrovsky

« Previous articles
Ignition coil
Ignition unit (models with fuel injection system)
Checking the ignition timing angle
Ignition distributor
Ignition system EEC IV — design description

Next articles »
Engine control unit
Carburetor stepper motor
Device for heating the intake manifold of engines with a carburetor
Engine Management System Relay
Setting the ignition timing and idle speed

See other similar articles for Ford cars:
• Description and operating principle of the engine without fuel… Ford Focus 1 (1998-2004)
• Checking the bottom and pipeline of the brake and fuel systems Ford Mondeo 1 and 2 (1993-2000)
• Fuel system of carburetor engines Ford Escort 3 (1980-1985)
• Replacing the fuel filter on cars with gasoline engines Ford Fiesta 4 (1996-1999)
• Fuel system diagnostics Ford Taurus 1 and 2 (1986-1994)
• Fuel filter water settling sensor (diesel only) Ford Transit 2 (1986-2000, diesel)