- lubrication of the splines of the gearbox clutch shaft with oil before connecting these units;
- when installing the clutch on the flywheel, it is necessary to center the clutch disc with a centering mandrel;
- if, when connecting the gearbox to the engine, the input shaft of the gearbox does not enter the clutch disc, it is necessary to turn the engine crankshaft a little;
- install a new front exhaust pipe gasket;
- fill the cooling system with the appropriate fluid and bleed air from the cooling system;
- check and, if necessary, adjust the ignition timing, as well as the engine idle speed and the CO concentration in the exhaust gases.
This publication was borrowed from the website [FORDBOOK.RU]