1. Place a reliable support under the gearbox housing or lift the power unit using a lifting mechanism.
2. Unscrew the nut securing the oxygen concentration sensor wiring harness connector…
3. …and move the wiring harness block to the side.
4. Unscrew the bolt securing the support to the bracket on the subframe…
5. …and remove the bolt.
6. Unscrew the two bolts and the stud bolt securing the support to the gearbox…
Note: The stud bolt used to secure the oxygen sensor wiring harness connector is screwed into the corresponding hole.
7. …and remove the rear support.
8. Install the rear powertrain suspension support in the reverse order of removal.
(For more information, please visit the website: «FORDBOOK»)