Spark plugs are used on Ford Focus II engines with a working volume of 1.4–1.8 litersNGK ITR6F13 (Motorcraft AGFS22IPG), and on engines with a working volume of 2.0 l - NGK TRGAP13 (Motorcraft AGPS22F13J). As a substitute for engines with a working volume of 1.6 liters, spark plugs can be used BRISK RR15YС1 or DENCO PT16VR13. The gap between the spark plug electrodes is 0.7–0.8 mm.
1. Remove the high-voltage wire tip from the spark plug being replaced.
2. Blow out the spark plug wells with compressed air to prevent dirt from getting into the engine cylinder when removing the spark plug.
3. Remove the spark plug…
4. …and remove it from the spark plug well.
NOTE: Inspect the spark plug and assess its condition by its appearance (see "Diagnosing engine condition by the appearance of spark plugs").
5. Check the gap between the spark plug electrodes with a round feeler gauge. It should be 0.7–0.8 mm.
6. If the gap differs from the specified value, adjust it by bending the side electrode.
WARNING: Adjust the gap only by bending the side electrode. Any bending of the center electrode will cause the spark plug insulator to break.
7. When installing spark plugs, first screw them in by hand (without a ratchet), and then tighten them with a wrench.
[This publication was borrowed from the website FORDBOOK]