1. Raise the front of the vehicle.
2. Apply penetrating lubricant such as WD-40 or similar to the nuts.
3. While holding the hinge pin from turning, unscrew the nut securing the hinge to the front suspension strut bracket…
4. …and remove the nut.
5. Disconnect the upper stabilizer bar joint from the front suspension bar bracket.
6. Similarly, unscrew the nut that secures the lower hinge pin of the strut to the stabilizer bar..
7. …disconnect the rack hinge and the rod…
8. …then remove the anti-roll bar.
9. To replace the anti-roll bar and its cushions, remove the front suspension crossmember (see "Removing and installing the front suspension crossmember").
10. Unscrew the two bolts securing the stabilizer bar brackets to the front suspension crossmember…
11. …and remove the barbell assembly with brackets and rubber pads.
12. Pry it up with a screwdriver…
13. …and remove the stabilizer bar mounting bracket.
14. Release the stabilizer bar cushion…
15. …and take it off.
16. Remove the second pillow in the same way.
17. Install the parts in the reverse order of removal; tighten bolts and nuts to the torque specified in Appendix 1.
18. Bleed the power steering system (see "Bleeding the power steering system").
NOTE: After replacing the stabilizer bar components, check and adjust the wheel alignment if necessary. Use the services of workshops with special equipment.