NOTE: We recommend replacing both front wheel hub bearings at the same time.
1. Remove the steering knuckle (see "Removing and installing the steering knuckle").
2. Install the puller and press the hub assembly with the bearing out of the steering knuckle.
WARNING: Once the hub has been removed, the bearing is not suitable for reuse and must be replaced.
WARNING: On vehicles equipped with ABS, the front hub bearing is equipped with a red seal. When replacing the bearing, purchase the same one, otherwise the ABS will not work, since the wheel speed sensor ring is made in one piece with the bearing.
NOTE: The original bearing is supplied as a spare part assembled with the hub, so further disassembly does not make sense.
3. Press the hub with the bearing into the steering knuckle until it stops.
4. Install the parts in the reverse order of removal.
5. Check and, if necessary, adjust the wheel alignment angles. Use the services of workshops with special equipment.