Note: We recommend replacing both front wheel hub bearings at the same time.
1. Remove the steering knuckle (see "Removal and installation the steering knuckle").
2. Install the puller and press the hub assembly with the bearing out of the steering knuckle.
Attention! After removing the hub, the bearing is not suitable for reuse, so it must be replaced.
Note: The original bearing is supplied as a spare part together with the hub, so further disassembly does not make sense.
3. Press the hub with the bearing into the steering knuckle until it stops.
4. Install the parts in the reverse order of removal.
5. Check and, if necessary, adjust the wheel alignment angles. Use the services of workshops with special equipment.