Replacing the rear seat belt

This subsection shows the replacement of the seat belt for the middle and left passengers in the rear seat. The right passenger seat belt is replaced in the same way.

You will need a TORX T45 key.



1. Fold forward the rear seat cushion and loosen the screw securing the seat belt buckles of the left and middle passengers in the rear seat..



2.... remove the bolt..



3.... and remove the locks.




4. Similarly remove a seat belt of the average passenger and the lock of a seat belt of the right passenger in a back seat.



5. Loosen the left passenger's seat belt lower anchor bolt..



6.... and, having unscrewed the screw, disconnect the lower mounting bracket from the body base.




7. Remove the middle lining of the left side of the body (cm. «Removal and installation of facings of a luggage carrier»).



8. Remove the screw securing the inertial coil to the sidewall..



9.... and remove the seat belt of the left passenger in the rear seat.

NOTE: The fastening screw of the inertial coil is protected from loss by a plastic washer put on its shaft and cannot be removed from the hole in the coil body.