Cooling Fan Motor — Removal and Installation (Focus 1)

Removal

1. Remove the cooling fan motor and housing. For more information, refer to the Motor and Housing chapter in this section.

2. Remove the electric motor.

Cut the clamps.
Unscrew the three nuts.

Installation

1. Install the elements back in place in reverse order.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Yaroslav Gorbunov

« Previous articles
Cooling fan — removal and installation
Radiator (Duratec ST 2.0 l) — removal and installation
Radiator (1.8L/2.0L/1.6L Zetec-E) — removal and installation
Radiator (1.6L Zetec-SE/1.4L) — removal and installation
Water pump (1.8 l diesel) — removal and installation

Next articles »
Electric motor and cooling fan housing (1.6L Zetec-SE/1.4L)
Electric motor and cooling fan housing (1.8L/2.0L/1.6L Zetec-E)
Expansion tank of the cooling system
Thermostat housing (1.6L Duratec) — removal and installation
Water Pump (1.6L Duratec) — Removal and Installation

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Focus 2

Focus Turnier 1
Focus 1