Name | Specification |
Bottom trim panel |
Withdrawal
1. General notes:
- Remove the doors, door seal, bottom trim panel trim, lower door hinge, fender, and inner fender before beginning repairs.
- Move the floor covering and wiring harness away from the work area.
- Notice the replacement part cutout in rack areas «A», racks «IN» and rear side panel.
2. Bottom trim panel
- Cutting locations.
- Be careful not to damage the panels below (under cut elements).
Installation
1. Bottom trim panel
- Prepare connection areas.
2.
NOTE: Apply two-component metal adhesive immediately before installing a new replacement part.
Bottom trim panel
- 1. Partially remove the damping material on the inside and overlap the overlap area.
- 2. Apply two component metal adhesive.
3. Bottom trim panel
- 1. Make an intermittent MIG weld.
- 2. Make a continuous MIG weld.
- 3. Perform a puddling weld.
Visitor comments