Driver Airbag Module — Removal and Installation

            0

Removal


WARNING: To avoid the risk of accidental deployment, the air bag control module backup power must be discharged. Wait at least one minute after disconnecting the battery ground cable(s) before attempting any repairs or adjustments to the Supplemental Restraint System (SRS) or any component(s) adjacent to the SRS sensors. Failure to follow this instruction could result in personal injury.


WARNING: Always wear safety glasses when working on a vehicle equipped with an air bag or when working with the air bag module. Failure to follow this instruction may result in personal injury.


WARNING: To minimize the possibility of premature air bag deployment, do not use radio key code storage devices when working with the supplemental restraint system. Failure to follow this instruction may result in injury.


WARNING: To minimize the risk of injury in the event of premature air bag deployment, always carry the charged air bag module with the air bag and trim cover facing away from your torso. Failure to follow this instruction may result in injury.


WARNING: To minimize the possibility of premature air bag deployment, charged air bag modules should only be installed on grounded workbenches and with the trim cover facing up. Failure to follow these instructions could result in personal injury.


WARNING: Never touch the tester probes to the electrical connectors of the air bag modules or any other component of the supplemental restraint system. Failure to follow this instruction may result in personal injury.



WARNING: Painting the driver air bag module trim cover or instrument panel may damage the trim cover and the air bags. Do not, under any circumstances, attempt to paint discolored or damaged air bag module trim covers or instrument panel. Install a new component. Failure to follow these instructions may result in personal injury.


1. Disconnect the battery ground cable. Refer to Section 414-01 for additional information.

2.
CAUTION: To avoid damage to the driver air bag module, wiring harness, or steering wheel, do not insert any tools between the driver air bag module and the steering wheel.


NOTE: Turn the steering wheel to access the air bag module mounting bolts.


Disconnect the driver's airbag module from the steering wheel.
  • 1. Remove the mounting bolts.
  • 2. Disconnect the driver airbag module mounting clips.



3. Remove the driver's airbag module.
  • Disconnect the driver airbag module electrical connector.



Installation


1.
WARNING: Always wear safety glasses when working on a vehicle equipped with an air bag or when working with the air bag module. Failure to follow this instruction may result in personal injury.



WARNING: To minimize the risk of injury in the event of premature air bag deployment, always carry the charged air bag module with the air bag and trim cover facing away from your torso. Failure to follow this instruction may result in injury.


WARNING: To minimize the possibility of premature air bag deployment, charged air bag modules should only be installed on grounded workbenches and with the trim cover facing up. Failure to follow these instructions could result in personal injury.


WARNING: Never touch the tester probes to the electrical connectors of the air bag modules or any other component of the supplemental restraint system. Failure to follow this instruction may result in personal injury.


WARNING: Painting the driver air bag module trim cover or instrument panel may damage the trim cover and the air bags. Do not, under any circumstances, attempt to paint discolored or damaged air bag module trim covers or instrument panel. Install a new component. Failure to follow these instructions may result in personal injury.


WARNING: The driver air bag module should only be rotated far enough to install the horn switch contact plate. Use extreme caution and if this procedure is interrupted for any reason, make sure the driver air bag module is facing up, i.e., with the trim cover facing up. Failure to follow these instructions could result in personal injury.


To install, follow the removal procedure in reverse order.







Link to this page in different formats
HTMLTextBB Code


Visitor comments


No comments yet





Focus 2 
Focus Turnier 1 
Focus 1