Unscrew the drive shaft mounting nut (pay attention to the sequence of the mounting parts).
Open the back cover, remove the inner lining (2 screws, 10 clamps). Using a wide-blade screwdriver and a rag, carefully press the shaped part out of the cutout in the back cover or from the clamps.
Disconnect plug connector 1 of the wiper motor.
Unscrew the ground wire 2.
Remove the 3 mounting bolts (arrows). Remove the engine together with the mount from the cutout in the rear cover.
Unscrew the motor from the mounting panel
Complete the installation in reverse order. First set the wiper motor to the parking position. Tighten the mounting bolts to 20 Nm.
Run a test run and adjust the wiper arm position on the glass if necessary.
The original post is on the web portal (FORDBOOK.RU)