Contents: Dismantling ↳ Installation ↳
Dismantling
Securely raise the rear of the vehicle and remove the wheels.
Release the handbrake lever.
Remove the center console.
Loosen the handbrake cable. To do this, remove clamp 1 and unscrew mounting nut 2.
Loosen the handbrake cable
Support the exhaust system with tripods - remove the intermediate muffler from the suspension.
Remove the middle rubber mount.
Remove the heat shield on the exhaust manifold.
Remove the handbrake cables from the rocker arm (arrows). Push the cable out of the guide and turn it 90°.
Loosen the bracket and bracket guide.
Disconnect the ABS sensor (arrow).
Remove the cables on the rocker arm
Disconnect the ABS sensor
Loosen the sleeve and cable - remove the guide (arrow).
Remove the handbrake cable and guide from the clamps.
Remove the guide
Remove the handbrake cable - pull back handbrake lever 1, unhook cable 2, remove clamp 3 from the guide, unhook handbrake cable 4.
Removing the handbrake cable
Installation
Assemble all structural elements in reverse order.
Perform a basic handbrake installation as described below.
Take the car on a short test drive, gently applying the handbrake and checking for even braking effect on both rear wheels.
The article was taken in its entirety from the specified website FordBook